Hubbardton-forge 137630 User Manual download pdf (Page 2)

Assembly & Installation Instructions A274

For Pendant 13-7630 Page 2 of 4

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

24824 Rev A

To Complete Fixture Assembly

(Figures 3 & 4)

Component Parts

A Fixture Pipe (2)

C Hex Nipple

F Canopy Pipe (2)

G Clutch (2)

H Plastic Clutch Sleeve (2)

I Set Screw (2)

J Canopy

Caution: Be sure power is off at the main breaker box prior to

installation.

1. Thread wires from the fixture pipe (A) through canopy (J).

Slide canopy (J) down fixture pipe (A) until it rest on top of fixture.

2. Thread the wires from the fixture pipe (A) into and through the

canopy pipe (F) up through the hex nipple (C).

3. Unscrew the clutch (G) from the canopy pipe (F); slide it across the

wires and onto the fixture pipe (A). Follow this with the plastic

clutch sleeve (H), oriented so the tapered end of the clutch sleeve

nests in the clutch (Figure 3).

4. Slide the canopy pipe (F) as far as necessary to give you the total

length of the fixture which you desire. Be careful not to scratch the

pipe surfaces and to pull excess wire up through the canopy pipe

(F). Screw clutch (G) onto canopy pipe (F). There must be a

minimum 1-1/2" of inner pipe inside the outer pipe. Hand-tighten

the clutch to temporarily hold this adjustment. The clutch is not

securely fastened at this point; do not depend on it to hold the

fixture.

Important: To ensure full connection strength, be sure the tapered

end of the plastic clutch sleeve is oriented toward the clutch when

assembled and securely tighten set screw

(Figure 3).

5. Continue with Ceiling Installation below.

(continued)

(Figure 3)

(Figure 4)

1 2 3 4

No comments

Hubbardton-forge 137630 User Manual Page 2