Hubbardton-forge 132200 User Manual download pdf (Page 2)

Assembly & Installation Instructions A111

For Trestle Four-Light Pendant 13-2200 Page 2 of 4

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

19830

4. Slide canopy (F) over canopy pipe (H) being careful not to

scratch finish. Slide down until the canopy rests against

clutch (J).

5. Thread studs (E) through appropriate holes in crossbar (D) to

match holes in canopy (F).

6. Attach crossbar (D) to both canopy pipes (H) using hex nut

nipple (C).

Note: Be sure both swivel notches are aligned in the same

direction. For sloped ceilings the notches should face towards

the down side.

7. Using two machine screws (not provided), fasten the crossbar

(D) to the electric box.

Note: A new electric box comes with screws. When replacing a

fixture, retain the existing screws for use with the new fixture.

8. Using suitable wire connectors (not provided) connect fixture

wires to supply (white to white and black to black). Connect all

ground wires to green ground screw.

Caution: Make sure wire connectors are twisted on securely, and

no bare wire is exposed.

9. Slide canopy (F) over threaded studs (E) and push firmly to

ceiling, making sure that no wires are pinched between

fixture canopy and ceiling. Fasten with knurled balls (G).

Be sure studs are fully seated in the knurled balls.

10. Refer instructions below and install glass/shade for option

that was purchased.

11. Restore electricity at main breaker.

(Figure 3)

(continued)

1 2 3 4

No comments

Hubbardton-forge 132200 User Manual Page 2