Hubbardton-forge 137670 User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
HUBBARDTONFORGE.COM
-, -   
154 RT. 30 SOUTH
CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge
®
. All rights reserved.
28106 A
Assembly & Installation Instructions
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.
To Install to Ceiling (Figure 5)
Component Parts
E Ceiling Bracket
I Set Screw (2)
J Canopy
L Crossbar
M #8 Screw (2)
N Threaded Stud (2)
O Barrel Knob (2)
P Ground Screw
1. Using two machine screws (not provided) fasten the cross-
bar (L) to the electric box using outer oval slots to orient
xture to desired hanging position.
Note: A new electric box comes with screws. When replacing an
existing xture, retain screws for use with the new xture.
2. Raise xture to ceiling aligning holes in crossbar (L) with
holes in ceiling bracket (E) install two #8 screws (M).
3. Using suitable wire connectors (not provided) connect
xture wires to supply (white to white and black to black).
Run a pigtail lead from crossbar ground screw (P) to the
junction box and connect all ground wires (bare copper or
green to bare copper or green).Push wires back into outlet
box.
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
4. Raise canopy (J) to ceiling over threaded studs (N) and push
firmly to ceiling, making sure that no wires are pinched
between canopy and ceiling. Fasten with barrel knob (O).
Note: Be sure both swivel notches are aligned in the same
direction. For sloped ceilings the notches should face towards the
down side.
5. Once the fixture is fastened to the ceiling, tighten the set
screw (I) firmly with hex wrench provided. Only after the set
screws (I) are tightened should you install the glass.
6. Refer instructions following to install diffuser and shade.
A328
Cavaletti Pendant 137670
Page 3 of 4
(Figure 5)
(Continued)
L
P
E
N
M
J
O
I
Page view 2
1 2 3 4

Comments to this Manuals

No comments