Hubbardton-forge 137670 User Manual Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.
HUBBARDTONFORGE.COM
-, -   
154 RT. 30 SOUTH
CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge
®
. All rights reserved.
28106 A
Assembly & Installation Instructions
To Complete Fixture Assembly (Figures 3 & 4)
Component Parts
A Fixture Pipe (2)
C Hex Nipple
F Canopy Pipe (2)
G Clutch (2)
H Plastic Clutch Sleeve (2)
I Set Screw (2)
J Canopy
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Thread wires from the xture pipe (A) through canopy (J).
Slide canopy (J) down xture pipe (A) until it rest on top of
xture.
2. Thread the wires from the xture pipe (A) into and through
the canopy pipe (F) up through the hex nipple (C).Raise
glass (I) until groove is aligned with thumb screws (J).
3. Unscrew the clutch (G) from the canopy pipe (F); slide it
across the wires and onto the xture pipe (A). Follow this
with the plastic clutch sleeve (H), oriented so the tapered
end of the clutch sleeve nests in the clutch (Figure 3).
4. Slide the canopy pipe (F) as far as necessary to give you
the total length of the xture which you desire. Be careful
not to scratch the pipe surfaces and to pull excess wire up
through the canopy pipe (F). Screw clutch (G) onto canopy
pipe (F). There must be a minimum 1-1/2" of inner pipe
inside the outer pipe. Hand-tighten the clutch to temporarily
hold this adjustment. The clutch is not securely fastened at
this point; do not depend on it to hold the xture.
Important: To ensure full connection strength, be sure the tapered
end of the plastic clutch sleeve is oriented toward the clutch when
assembled and securely tighten set screw (Figure 3).
5. Continue with Ceiling Installation that follow.
A328
Cavaletti Pendant 137670
Page 2 of 4
(Figure 3)
I
F
(Figure 4)
J
(Continued)
LARGE DIAMETER PIPE
PLASTIC CLUTCH SLEEVE
CLUTCH
H
C
F
G
I
A
J
Page view 1
1 2 3 4

Comments to this Manuals

No comments