Installation Instructions A149
For Medium Ellipse Semi-Flush 12-7525, 12-7525F, 36-7525 & 36-7525F
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21186
To Install Fixture (Figure 1)
Component Parts
A Crossbar
B Ground Screw
C Threaded Stud (2)
D Canopy
E Barrel Knobs (2)
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in cross bar (A) to match hole
centers in canopy (D). Move ground screw (B) to another available threaded hole if necessary.
3. Using two machine screws (not provided) fasten cross bar (A) to the electric box using outer oval holes to orient
fixture to desired hanging position.
Note: A new electric box comes with screws. When replacing an existing
fixture, retain the screws for use with the new fixture.
5. Using suitable wire connectors (not provided), connect fixture wires to supply wires (white to white or ribbed and
black to black or smooth. Connect all ground wires to green ground screw (B).
Caution: Make sure wire
connectors are twisted on securely, and no bare wire is exposed.
6. Slide fixture canopy (D) over threaded studs and push firmly to ceiling, making sure that no wires are pinched
between fixture canopy and ceiling. Fasten with barrel knobs (E). Be sure studs (C) are fully seated in the barrel
knobs (E).
7. Refer to instructions below to install glass & bulb.
To Install Glass (Figure 2)
Component Parts
F Socket
G Glass
H Retaining Ring
1. Slip glass (G) over socket (F).
2. Thread retaining ring (H) onto socket (F) until it rests on inside of glass (G).
Do not over tighten.
3. Install light bulbs and restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Fi
ure 1
Fi
ure
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals