Installation Instructions B128
For Ellipse Sconces 207525, 207525F, 207535 & 207535F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
21028
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
For fixtures requiring assembly, please refer to assembly instructions before installation.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1 & 2)
Component Parts
A Wall Mount Bracket
B Anchors (4)
C #10 Screws (4)
D Fixture Assembly
E #8 Black Screws (4)
F Green Ground Screw
G Cupped Washer
H Wireway Cover
I Barrel Knob (2)
Caution: Be sure power is off at the main
breaker box prior to installation.
1. Carefully unpack the fixture from the
carton.
2. Center the wall mount bracket (A) over
the electrical box being sure to hold it
plum and level. With a pencil, mark the
location of all mounting holes in the w
mount bracket on the wall behind.
IMPORTANT: Wall mount bracket must be secured to
a solidly mounted electrical box and/or a framing
member in at least two locations. Do not depend on
drywall anchors alone to support this fixture. If in doubt, contact a qualified electrician.
Put the wall mount bracket down and drill 1/4" holes in the locations marked on the wall. For holes using anchors,
place the tapered end of the anchors (B) into the holes and gently tap them flush to the wall using a light weight
hammer.
This illustration represents a typical fixture
and may not match every style.
(Figure 1)
all
3. Thread the wires in the electrical box through the center hole in the wall mount bracket while moving the bracket
into position. Using the 1" #10 screws (C), screw the bracket securely to the wall. Be careful not to over-tighten or
strip the anchors.
4. Thread the black # 8 screws (E) up through the holes in the top of the wall mount bracket (A). Leave the bottom
screws out for now.
5. Remove the wireway cover (H) and save for later installation.
6. Hold the fixture assembly (D) close to the wall mount bracket (A) ground the mounting bracket using the green
ground screw (F) and cupped washer (G) to secure a pigtail lead to the bracket.
(continued)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals